SD2IEC - nowinki!

[suchy]

2011-12-18 - release 0.10.2
        - Bugfix: End of generated raw directory was incorrect
        - Bugfix: Various compilation fixes when fastloaders are disabled
        - ULoad M3 automatically exits when ATN becomes active
        - Minor code space improvements
        - New fastloader: ELoad Version 1 (EasyProg)

... nowy firmware dla SD2IEC.

firmware 0.10.2

[Kisiel]

co ciekawe to informacja jako pierwsza pojawila sie na c64power.. o tutaj:
http://www.c64power.com/forum/index.php?action=vthread&forum=12&topic=2628

[suchy]

... tak, tym razem Raf mnie wyprzedzil na c64power, ale juz tradycyjnie podaje rowniez tutaj

[suchy]

Dzisiaj pojawila sie nowa wersja bootloadera (0.3):

2012-01-22 - release 0.3
        - further size optimizations
        - enable FAT12 on uIEC3

... tak z ciekawosci porownalem na szybko wage plikow .hex - stary (0.2: 11572 bajtow) z nowym (0.3: 11392 bajtow) no i wychodzi, ze lzejszy o 180 bajtow, wiec chlopaki cos tam faktycznie odchudzili dla SD2IEC (dla uIEC3 zalaczyli FAT12, wiec ten troche utyl).

W dzialaniu bootloadera nic sie nie zmienilo:

FAT16 and FAT32 are always supported, FAT12 only if enabled. MMC, SD
and SDHC cards with a supported file system should all work.

The boot loader turns on the red LED while it is running. If it
cannot find a valid application in the chip, it will flash the red LED
for two seconds and try to find a valid file once more. During card
accesses the green LED is on, during the actual flash operation the
green LED flickers rapidly.